Changing the tv format setting, Resetting the main unit, Specifications – Pioneer VSX-819H-S User Manual

Page 70: Additional information 12

Advertising
background image

Additional information

12

70

En

Changing the TV format setting

If the System Setup menu is not displayed
correctly, it may be that the TV system is set
incorrectly for your country or region.

1 Switch the receiver into standby.

2 While holding down the ‘TUNE +’ button,

press and hold the STANDBY/ON button

for about two seconds.
The display shows the new setting (PAL or
NTSC).

Resetting the main unit

Use this procedure to reset all the receiver’s
settings to the factory default. Use the front
panel controls to do this.

1 Switch the receiver into standby.

2 While holding down the BAND button,

press and hold the STANDBY/ON button

for about two seconds.

3 When you see RESET? appear in the

display, press ‘AUTO SURROUND/STREAM

DIRECT’.

OK? shows in the display.

4 Press ‘STEREO/A.L.C.’ to confirm.

OK appears in the display to indicate that the
receiver has been reset to the factory settings.

Specifications

Audio section

FTC power output

. . . . . . . . . . . . . . . . . . . . . . . . . . . .65 W + 65 W

(STEREO, 20 Hz to 20 kHz, 8

Ω, 0.2 %)

Rated power output (Front, Center, Surround)

. . . . . . . . .125 W per channel (1 kHz, 6

Ω, 1 %)

Maximum power output (Front, Center, Surround)

. . . . . . . .150 W per channel (1 kHz, 6

Ω, 10 %)

Total Harmonic Distortion

. . . . . . 0.06 % (20 Hz to 20 kHz, 8

Ω, 85 W/ch)

Guaranteed speaker impedance

FRONT : A, B . . . . . . . . . . . . . . . . . . 6

Ω to 16 Ω

FRONT : A+B . . . . . . . . . . . . . . . . . 12

Ω to 16 Ω

SURROUND, CENTER. . . . . . . . . . . 6

Ω to 16 Ω

Input (Sensitivity/Impedance)

LINE . . . . . . . . . . . . . . . . . . . . . . 200 mV/47 k

Ω

Output (Level/Impedance)

REC . . . . . . . . . . . . . . . . . . . . . . . 200 mV/330

Ω

ZONE 2 . . . . . . . . . . . . . . . . . . . . . 200 mV/1 k

Ω

Signal-to-Noise Ratio
(IHF, short circuited, A network)

LINE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 98 dB

Tuner Section

FM Frequency Range . . . . 87.5 MHz to 108 MHz
Antenna Input . . . . . . . . . . . . . 75

Ω unbalanced

AM Frequency Range

9 kHz step . . . . . . . . . . . . . 531 kHz to 1602 kHz

10 kHz step . . . . . . . . . . . . 530 kHz to 1700 kHz
Antenna . . . . . . . . . . . . . . . . . . . . . Loop antenna

Video Section

Signal level

Composite . . . . . . . . . . . . . . . . . . 1 Vp-p (75

Ω

)

Component Video . . . . . . . . Y: 1.0 Vp-p (75

Ω

)

PB, PR: 0.7 Vp-p (75

Ω

)

Corresponding maximum resolution

Component Video . . . . . . . . . . . 1080p (1125p)

Digital I/O

HDMI terminal . . . . . . . . . . . . . . 19-pin (Not DVI)
HDMI output type . . . . . . . . . . . . . . . 5 V, 100 mA
iPod terminal . . . . . . . USB + Video (Composite)

12_additional_info.fm 70 ページ 2009年2月6日 金曜日 午後1時32分

Advertising
This manual is related to the following products: