Panasonic PT-D9610U - Manual (Page 47)

47
Adjusting the picture automatically
The automatic adjustment (AUTO SETUP) is a function to automatically adjust the resolution, clock phase, and
picture position when inputting an analog RGB signal consisting of dots like a computer signal. (The input of a
moving picture signal or any signal other than analog RGB signals cannot enable this function.)
It is recommendable for the automatic adjustment to input a picture signal including a brighter white box around the
outside of the perimeter of a basic picture with clear, black-and-white characters and not including a halftone like a
photograph or CG.
1. General automatic adjustment
Adjustment procedure
Press the MENU button. ... The MENU screen will be displayed.
Press the UP (
) and DOWN ( ) arrow buttons to select AUTO SETUP.
Press the ENTER button. ... This completes the automatic adjustment.
• “ NOW CALCULATION “ is displayed during automatic adjustment.
Initial input display after automatic adjustment.
• If automatic adjustment completes correctly, "COMPLETED" will be displayed. Even if this happens,
there may still be some cases where the clock phase will not be correct. In such cases, adjust the
clock phase manually.
• Adjust according to the following page when performing automatic adjustment of special signals and
wide aspect (16:9 etc.) signals.
• If inputting a picture in which the edge of the screen is not known, or a dark picture, when starting the
automatic adjustment the message “INCOMPLETED” will be displayed and the picture will not be
adjusted automatically.
If this happens, you will need to manually adjust settings such as INPUT RESOLUTION, CLOCK
PHASE and SHIFT.
• Some types of personal computer may not support automatic adjustment.
• Some types of synchronizing signals for C-SYNC and G-SYNC may not support the automatic adjustment.
• The picture may become distorted for approximately 4 seconds while automatic adjustment is being
carried out, but this is normal.
• Adjustment is required for each of the input signals.
• Press MENU during automatic adjustment to cancel.
NOTE