Panasonic PT-D9610U - Manual (Page 77)

77
Using the network module
The network module for this unit has a LAN interface, so the unit can be controlled from the web browser of a PC.
The network module has an automatic send function for e-mail. Mail can be sent to a previously set e-mail address
when a problem occurs, or when the set value for the lamp usage time is attained.
Connection example
A LAN cable is necessary when using the network module.
Hub
LAN cable (straight) LAN cable (straight)
PC
Projector
• A web browser is necessary when using this function. Check beforehand that a web browser is available.
• Compatible with a PC running Microsoft Windows 95/98/Me or WindowsNT4.0 / Windows2000.
• Suitable web browsers are Internet Explorer 5.01 or higher, or Netscape Navigator/Communicator 4.75 or
higher.
• When using the e-mail function, it is necessary to communicate with the e-mail server. Check that e-mail can
be used beforehand.
• LAN cable should be a straight type that is category 5 compatible.
• LAN cable length to be less than 100 m.
Network module parts identification and function
Network Module
ON-LINE
SERIAL
FUNCTION
TRANSMIT RECEIVE
LAN terminal(10Base-T/100Base-TX)
For connection of LAN cable.
Serial Input/Output terminal
This terminal is for the service representative.
Do not connect anything to it.. Function switch
Returns network module settings
to the factory shipment condition.
Online lamp
Lights up when preparation for LAN connection is
complete. When unlit or flashing, indicates that
preparation for LAN connection is in progress. LAN signal transmission status lamp
Flashes during transmission.
LAN signal reception status lamp
Flashes during reception.
• If you touch the LAN terminal with a hand (body) charged with static electricity, it may cause
malfunction due to discharge of static electricity. Be careful not to touch the LAN terminal or metal
parts of the LAN cable.
NOTE