Panasonic PT-D9610U - Manual (Page 8)

8
Precautions on handling
CAUTION
Setting-up
The following points should always be observed when setting up this projector.
A dedicated power supply must be used.
• Ask the place of purchase to carry out any electrical work which may be required to provide a 14 A, 200 V - 240 V
AC (single phase) power supply for the projector alone to use.
Avoid setting up in places which are subject to vibration or shocks.
• If the projector is set up in a location with strong vibration, such as near a motor, or if it is installed inside a
vehicle or on board a ship, the projector may be subjected to vibration or shocks which can damage the internal
parts and cause malfunctions or accidents. Accordingly, set up the projector in a place which is free from such
vibrations and shocks.
Do not place the projector near high-voltage power lines or motors.
• If the projector is set up near high-voltage power lines or motors, it may be subjected to electrical interference.
The projection distance will vary depending on the projection lens (sold separately)
which is used.
• Select a projection lens which is suitable for the amount of space available at the setting-up location.
If installing the projector to the ceiling, be sure to have a qualified technician carry out
the work.
• If suspending the projector from the ceiling, you will need to obtain the ceiling mount bracket which is sold
separately. Also be sure to have the work performed by a qualified technician.
Do not move the projector after it has been installed and adjusted.
• After installation and adjustment of the projector have been completed, do not change the distance from the
projector to the screen, and do not move the position of the projector, otherwise the colors may become
unbalanced and readjustment may be necessary. Be particularly careful of this when the projector is installed
using the floor method.
Allow enough space around the projector for maintenance to be carried out.
• Leave at least 80 cm(2.6 feet) of free space on all sides of the projector to allow enough room for adjustments
and maintenance to be carried out.