Philips AURILIUM PSC805 - Manual (Page 14)

Philips Sound Solutions
PSC805 Aurilium™ Sound Processor Users Guide 9
Fastening screw
Horizontal Position
Vertical Position
2.2. Quick Installation Guide
Installing the Aurilium is very simple and can be done in three easy steps. However, if you need
more information, please refer to the Detailed Installation Guide section following this section.
Step 1:
Attach the base to the desired location as shown in Figure 3, depending on how you wish to
position the unit. Fasten the base to the Aurilium case with the included screw. Do not over
tighten as this may cause damage to the case.
Figure 3
Step 2:
Connect the USB cable (included) to the USB connector on the back of the Aurilium, and then
attach the other end to the USB port of the PC. The USB port may be in the back or front of the
PC as most new computers have USB ports in either location. Refer to the documentation of
your computer to locate the USB port. Connect self-powered speakers to the audio jacks
located on the back of the Aurilium. If you have more than two speakers, make sure you
connect the correct speakers to the appropriate jacks.
You may have to use a USB hub if all the USB ports of your PC are being used. If you are not
familiar with USB hubs, please refer to Appendix B, USB Hub Considerations of this users
guide.
Step 3:
Install the Philips Sound Agent 2 using the installation CD (included). Place the CD in the CD
drive and let Autorun launch the PSA2 Autolauncher installation panel. Click on the “Install
Philips Sound Agent 2” button and follow the instructions on the screen.
If Autorun is disabled, go to the Start menu at the bottom of your screen and click on Run. Type
the following in the Run window and click OK:
D:\autolauncher.exe (where D:\ is your CD drive designator letter).
Note: Not installing PSA2 will limit the Aurilium sound processor to stereo output only
and its advanced features will be inoperative.