Philips Network Adaper - Manual (Page 8)

15 14
SMART SMART PLUG PLUG
S-VIDEO S-VIDEO
VIDEO VIDEO AUDIO AUDIO
RF IN RF IN
VIDEO VIDEO AUDIO AUDIO
IN IN OUT OUT
OUT OUT IN IN
S-VIDEO S-VIDEO S-AUDIO S-AUDIO S-AUDIO S-AUDIO
VGA IN VGA IN VGA OUT VGA OUT
RS 232 RS 232
MENU CH VOL POWER
+ –
▼ ▲ ▼ ▲ ▼ ▲
SLEEP
VIDEO VIDEO AUDIO AUDIO
RF IN RF IN
S-VIDEO S-VIDEO S-AUDIO S-AUDIO
CLONE CLONE
PORT
PORT
CC
2
ANTENNA
OUT
ANTENNA IN
VIDEO AUDIO
IN IN
OUT OUT
3
1
Video Plug Cable
(not supplied)
Optional VCR
Rear Jacks of
the Net1Card
Assembly
Audio
RCA
Phono
Plug
Cable
(not sup-
plied)
Jack Panel of
Optional Mono
VCR
Back of TV
Front Control Panel of TV
A
UDIO
/V
IDEO
I
NPUTS
Y ou can view the playback of VCR tapes
(Video Disc Players, Camcorders, etc.) by
using the AUDIO and VIDEO INPUT jacks
(on the Net1Card Cover assembly).
For example: Use the following steps to view
the playback of a pre-recorded VCR tape
Connect the VIDEO and AUDIO IN(put)
jacks on the TV to the AUDIO and VIDEO
OUT(put) jacks on the VCR.
Press the CHANNEL ▼ button three channels
below the lowest broadcast channel to activate the
AUX inputs.
Turn the VCR ON. Insert a pre-recorded tape
into the VCR. Press PLAY on the VCR to view the
tape on the TV.
BEGIN
Remember, when your through using the
A/V INPUT (OUTPUT) jacks, change the
channel number back to the desired viewing chan-
nel (or the screen will remain blank).
NOTE: If you have a stereo VCR, connect only
the red (or right) plug to the audio jack on the
back of the Net1Card.
S MART H ELP
Net 1Card IB 2/15/00 12:17 PM Page 14