PhatNoise KDC-MP8029 - Manual (Page 13)

English | 13
• * Function of the KDC-X8529
5 Exit display control mode
Press the [6] ("RTN") button.
• Under the display type other than "Display Type D",
the function item is not displayed. When the display
type other than "Display Type D" is selected, press [1]
to [6] buttons or [NEXT] button. The function item will
be displayed approximately 5 seconds.
• The information can be switched by the Display
Type. Refer to the page on the following table for the
methods to switch by the Display Type.
Display Type A B C D E
Graphic 1 13 13 — — —
Text 2 — 14 — — —
Upper 4 — — 15 15 —
Middle 5 — — 15 — —
Lower 6 — — 15 15 —
G-Analyzer 9 — — — — 18
Display Type A/ Display Type B
Graphic part/ Spectrum Analyzer
Display Switching
Switching the graphic Display/ Spectrum analyzer
display.
1 Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "DISP" is
displayed above the [2] button.
Refer to <Notes on Multi-function Key System>
(page 8).
2 Enter display control mode
Press the [2] ("DISP") button.
3 Select the display mode
Press the [1] ("MODE") button.
4 Select the display Type
Push the Control knob to [ 4] or [¢].
Select the "Display Type A"/ "Display Type B"
display.
5 Select the graphic/ spectrum analyzer
display
Press the [3] ("Graph") button.
6 Select the graphic/ spectrum analyzer
display part display
Push the Control knob to [
4] or [¢].
Each time the button is pressed, the graphic
display/ spectrum analyzer display switches as
shown below.
Graphic display/ Spectrum Analyzer display
Movie 1
Movie 2
Movie 3*
Spectrum analyzer 1*
Spectrum analyzer 2*
Spectrum analyzer 3*
Spectrum analyzer 4*
Spectrum analyzer 5*
Wallpaper
• * Function of the KDC-X8529
• KDC-MP8029 doesn't display the Spectrum analyzer.
7 Exit display control mode
Press the [6] ("RTN") button.
• The setting of this function is available while "Display
Type A"/ "Display Type B" is selected for the Display
mode.