ProForm PFEL54931 User Manual

Page 6

Advertising
background image

6

2. While another person lifts the back of the Frame (1),

attach the Rear Stabilizer (4) to the Frame with two
M10 x 112mm Carriage Bolts (34) and two M10 Nylon
Locknuts (106).

34

4

1

3

59

108

18

45

102

104

Grease

Tubes

103

108

45

102

18

1

3. Identify the Frame Axle (104), which is the longest

axle. Slide an M8.5 Washer (45) and a Ramp Cap
(102) onto an M8 x 19mm Patch Screw (108). Tighten
the Patch Screw into one end of the Frame Axle (104).
Next, apply a small amount of the included grease to
the Frame Axle.

Locate the two Frame Bushings (103) in the Frame (1).
Press a Ramp Shield (18) onto each Frame Bushing.
Next, align the indicated tubes on the Ramp (59) with
the Ramp Shields.

Make sure that the Ramp is

turned as shown. Insert the Frame Axle (104) into the
Ramp, the Ramp Shields, and the Frame Bushings.
Note: It may be helpful to use a rubber mallet to insert
the Frame Axle.

Slide an M8.5 Washer (45) and a Ramp Cap (102)
onto an M8 x 19mm Patch Screw (108). Tighten the
Patch Screw into the other end of the Frame Axle (104).

2

106

106

4. Identify the Incline Axle (100), which is the longest

remaining axle. Slide an M6 Large Washer (94) onto
an M6 x 16mm Button Screw (109). Tighten the Button
Screw into one end of the Incline Axle (100). Next,
apply a small amount of grease to the Incline Axle.

Raise the Ramp (59). Insert the Incline Axle (100)
through one side of the Ramp, through a Ramp
Spacer (99), through the end of the Incline Motor (82),
through another Ramp Spacer (99), and then through
the other side of the Ramp.

Slide an M6 Large Washer (94) onto an M6 x 16mm
Button Screw (109). Tighten the Button Screw into the
other end of the Incline Axle (100).

99

59

94

109

100

82

94

109

4

1. Identify the Front Stabilizer (3). While another person

lifts the front of the Frame (1), attach the Front
Stabilizer to the Frame with two M10 x 112mm
Carriage Bolts (34) and two M10 Nylon Locknuts
(106).

Make sure that the Front Stabilizer is turned

so the Wheels (32) are not touching the floor.

3

106

32

32

34

1

1

Grease

Advertising