Panasonic EW3003 - Manual (Page 10)

17 18
Care and Maintenance
1. Use a dry, soft cloth to clean the device. If desired, use a cloth lightly
dampened with tap water and a mild detergent to clean the device.
DO NOT use alcohol, benzine, thinner or other harsh chemicals to clean
the device or cuff.
2. When the unit will not be used for a long time (30 days or more), be sure
to remove the batteries. Otherwise, the batteries may leak and damage
the unit.
Storing the Monitor
1. Fold the pressure cuff as indicated.
(Fig. 11-a)
2. Put the blood pressure monitor in
the storage case. (Fig. 11-b)
• Be sure not to pinch the pressure
cuff or 2cm gauge when closing the
case.
If the 2cm gauge is attached,
straighten it out.
Fig. 11-a
Fig. 11-b
NOTE: When the batteries are removed, the date, time, and measurement
record are erased. Set the date and time again the next time you
use the unit.
Troubleshooting
Display
The blinks on
the display
Status before error
Pressurization to above
280 mmHg was
performed.
(Re-pressurization was
performed several
times.)
Pressure decreased
suddenly and
appeared in the display.
mark only blinks a
few times, or not at all.
Cuff does not inflate.
Check points
Check whether
measurements are
being taken correctly
and whether you are
assuming the correct
posture. Make sure
the unit is on the palm
side of the wrist.
(See pages 9-10.)
Check whether the
pressure cuff is
attached to your wrist
correctly. Make sure
the unit is on the palm
side of the wrist.
(See page 9.)