Proson RV 2200 - Manual (Page 14)

13
Repeat the above steps 1 to 3 to mem-
orize other stations.
4
After selecting the tuner as an input
source, select the preset mode.
1
Listening to FM stereo broadcasts
• Then “PRESET” lights up.
MEMORY BACKUP FUNCTION
The following items, set before the receiver is
turned off, are memorized.
• INPUT SELECTOR settings
• Preset stations,etc.
Note
• If the electricity fails or the AC input cord is dis-
connected for more than several days, they are
all cleared. So you should memorize them
again.
• While listening to FM broadcasts,
• Each time this button is pressed,
the FM mode changes as follows:
Scanning preset stations in sequence
• The receiver will start scanning the stations in the
preset sequence.
• At the desired station, press this button again to
stop scanning.
• When using the NUMERIC buttons on the remote
control.
Examples) For “3” :
For “15” :
For “30” :
• To select numbers less than 10, press "0" and then
the number. As an example, to select number 5,
press "0" and "5". (Optionally, you may press just
the number "5" and then wait a few seconds.)
Tuning to preset stations
Select the desired preset number.
2
Select the desired preset number
(1~30) and press the MEMORY button.
3
• When using the NUMERIC buttons on the remote
control.
Examples) For “3” :
For “15” :
For “30” :
• The station has now been stored in the memory.
• When using the NUMERIC buttons, the station is
stored automatically without pressing the MEMORY
button.
• A stored frequency is erased from the memory by
storing another frequency in its place.
• If “MEM” goes off, start again from the above step 2.
• When FM stereo broadcasts are poor because of
weak broadcast signals, select the FM mono
mode to reduce the noise, then FM broadcasts
are reproduced in monaural sound.