ProForm PFANBE2525.0 - Manual (Page 5)

5
ASSEMBLY
1. Attach a Seat Base Bumper (31) to the Left Base
(33) with an M4 x 16mm Self-tapping Screw (38)
and an M4 Washer (39).
The Uprights (4) can be assembled at an
Olympic width or a mid-width.
For an Olympic width, attach an Upright (4) to
the outside of the Left Base (33) with an M10 x
55mm Button Bolt (47) and an M10 Washer (37);
and with two M10 x 95mm Button Bolts (46) and
two M10 Nylon Locknuts (41).
Attach the Left Foot (16) to the Left Base (33)
with two M4 x 16mm Self-tapping Screws (38)
and two M4 Washers (39).
For a Mid-width, attach an Upright (4) to the
inside of the Left Base (33) as described above
(see the inset drawing). Then attach the Right
Foot (17) to the Left Base as described above.
Repeat this step with the Right Base (not
shown). Make sure that the Right Base is ori-
ented as shown in step 3.
1
17
33
4
4
33
31
39
38
39
39
38
16
41
46
37
47
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two people.
• Make sure that there is enough clearance to walk
around the weight bench as you assemble it.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• For help identifying small parts, use the PART
IDENTIFICATION CHART.
The included hex keys and the follow-
ing tools (not included) may be required for
assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
• Clear tape or masking tape, and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Assembly Easier
Everything in this manual is designed to ensure
that the weight bench can be assembled suc-
cessfully by anyone. Most people find that by
setting aside plenty of time, assembly will go
smoothly.