ProForm AT 500 PFTL49906.0 User Manual
Page 11
11
13. Align the holes in the Left Base Leg Cover (33)
with the holes in the Base (37). Note: It may be
necessary to press on the Left Base Leg Cover to
align the holes.
Attach the Left Base Leg Cover (33) with three
1/2" Screws (83).
Be careful not to overtighten
the Screws.
37
83
83
83
13
14. Tighten a 1/2" Screw (83) into each side of the
Base (37) and each Base Leg Cover (33, 42).
Be
careful not to overtighten the Screws.
Remove the plastic packaging from the bottom of
the Belly Pan (49).
83
42
33
49
37
14
33
15. Carefully raise the Uprights (38, 39).
Attach the Latch Housing (91) to the Left Upright
(38) with two 3/4” Screws (3).
Make sure that
the large hole in the Latch Housing is on the
side shown. Do not overtighten the Screws.
Remove the knob from the pin. Make sure that
the collar and the spring are on the pin. Insert
the pin into the Latch Housing (91), and tighten
the knob back onto the pin.
16.
Make sure that all parts are properly tight-
ened before you use the treadmill. Note: Extra
hardware may be included. Keep the included
hex keys in a secure place; the large hex key is
used to adjust the walking belt (see page 20). To
protect the floor or carpet, place a mat under the
treadmill.
3
91
38
15
Knob
Pin
Collar
Spring
Large
Hole
39