Pelco TLR3040 - Manual (Page 45)

Pelco Manual C671M (1/01) 45
3. Press PLAY to start playback. (If noise occurs, adjust the tracking. Refer to the
Tracking Adjustment section.)
When a pre-recorded tape is used for recording, colored noise may appear on the
beginning of the playback picture.
4. Press STOP to halt playback.
• Turn the SHUTTLE ring left to rewind the tape when the VCR is stopped. Press
STOP to stop.
• Turn the SHUTTLE ring right to fast forward the tape when the VCR is stopped.
Press STOP to stop.
• Fast forward/rewind time of a T-160 tape is about 160 seconds, but can vary
according to the type of tape.
PLAYBACK MODE
• When you press the REC/PLAY MODE button, playback mode is switched in the
following order: 8H, L24H, L40H, 8H (for a tape recorded in one of these modes).
• Picture jitter or noise may occur when the tape is played back in L24H or L40H mode
(even if the tape was recorded in that mode).
• A tape recorded in SP mode using another VCR can only be played back in 2H mode.
AUDIO PLAYBACK
There is normal sound playback only when a tape recorded in 8H, L24H, or L40H mode is
played back in its respective mode.
Table F. Audio Playback and Picture Quality
Playback Mode 2H/8H L24H L40H
Audio Playback Available Available Available
Picture Quality Good Vibrating Vibrating
END OF TAPE
When the end of the tape is reached, the following functions are performed automatically
during playback or fast forwarding.
Table G. End of Tape Actions
Tape End Selected REPEAT or ALARM•PROT STOP or REWIND
Playback The tape automatically rewinds to Stop
the beginning and stops.
Fast Forward Stop Stop