ProForm CardioCross Trainer PFEL39032 User Manual

Page 12

Advertising
background image

12

To reset the displays, press the On/Reset button.

Note: The con-

sole can show

speed and dis-

tance in either

miles or kilo-

meters. The let-

ters MPH or KM/H will appear in the lower section

of the large display to show which system of mea-

surement is selected. To change the system of

measurement, hold down the On/Reset button for

about six seconds. Note: When the button is held

down, the fan will turn on for a moment. When the

batteries are replaced, it may be necessary to res-

elect the desired system of measurement.

Measure your heart rate if desired.

If there are

thin sheets of

plastic on the

metal contacts

on the hand-

grips, peel off

the plastic. To

use the hand-

grip pulse sen-

sor, hold the handgrips with your palms resting

against the metal contacts. Avoid moving your

hands. When your pulse is detected, the heart-

shaped indicator in the large display will flash

each time your heart beats. After a moment, two

dashes (– –) will appear and then your heart rate

will be shown.

For the most accurate heart rate reading, continue

to hold the handgrips for about 30 seconds. Note:

When you first hold the handgrips, the large dis-

play will show your heart rate continuously for 30

seconds. The display will then show your heart

rate along with other feedback modes.

Turn on the fan if desired.

To turn on the

fan at low speed,

press the fan

button. To turn

on the fan at

high speed,

press the fan

button a second

time. To turn off

the fan, press the fan button a third time. Note: If

the fan is turned on but the pedals are not moved

for thirty seconds, the fan will automatically turn

off to conserve the batteries.

Rotate the thumb wheel on the right side of the

console to pivot the fan to the desired angle.

When you are finished exercising, the console

will automatically turn off.

If the pedals are not moved for a few seconds,

the displays will pause and the time will flash in

the large display.

If the pedals are not moved and the console but-

tons are not pressed for a few minutes, the con-

sole will turn off to conserve the batteries.

7

6

5

Metal

Contacts

Thumb

Wheel

Fan

Button

Advertising