Panasonic SC-EN17 - Manual (Page 2)

2
To clean this unit, wipe with a soft, dry cloth.
Maintenance
Placement of speakers
You can remove the speaker cover.
Note
• Keep your speakers at least 10 mm (13/32") away from the system for proper ventilation.
• These speakers do not have magnetic shielding. Do not place them near
televisions, personal computers or other devices easily influenced by
magnetism.
• To avoid damage to the speakers, do not touch the speaker cones if you
have taken the covers off.
Connections
Caution
• Use the speakers only with the recommended system.
Failure to do so may lead to damage to the amplifier
and/or the speakers, and may result in the risk of fire.
Consult a qualified service person if damage has
occurred or if you experience a sudden change in
performance.
• Do not attach these speakers to walls or ceilings.
1 Speakers
Before connecting, twist off
the tip.
R
L
1 2
Red
Red Black
Black
Copper (+)
Copper (+)
Silver (–)
Silver (–)
2 AM loop antenna
Stand the antenna up on its base.
Use
Note
• An analog player with a built-in phono equalizer can be
connected.
• For details, refer to the instruction manual of the other
equipment.
Reduce the volume before connection.
Plug type: 3.5 mm (
1 /
8
″ ) stereo
Note
Avoid listening for prolonged periods of
time to prevent hearing damage.
Start Playback from the
other source.
Connect the AC power
supply cord only after all
other connections have
been made.
Conserving power
The unit consumes power
even when it is turned off
with [POWER8]. To save
power when the unit is not
to be used for a long time,
unplug it from the
household AC outlet.
If the unit is left unplugged
for longer than
approximately two weeks,
all settings will revert to the
factory settings.
Remember to reset the
radio stations and any
other memory items before
using the unit again.
AUX
OUT
(R)
(L)
Tape deck, etc.
PHONES
Headphones
(Not included)
Other equipment
(Cords and equipment not included.)
Plug type:
3.5 mm (
1 /
8
″ )
stereo
Select “AUX”
The socket outlet shall be installed near the equipment and easily accessible or the mains plug or an appliance coupler shall remain readily operable.
Remote control
To household AC
outlet
3 AC power supply cord
For units with PX printed on the outer packaging
Note
This unit will be seriously damaged or fall to operate
correctly if this setting is not made correctly.
Power plug
If the power plug will not fit
your socket, use the power
plug adaptor (included).
VOLT
ADJ
110-
127 V
220-
240 V
VOLTAGE ADJUST SWITCH
IS LOCATED AT BOTTOM.
Voltage setting
Set the voltage selector to the
voltage setting for the area in
which the unit will be used.
110-127 V / 220-240 V
Use the numbers indicated in parentheses when asking for
replacement parts.
In U.S.A. to order accessories, refer to "Accessory Purchases" on page 8.
Supplied accessories
1 Remote control
(EUR7711170)
2 Batteries
1 AM loop antenna
(G0ZZ00002036)
1 Power plug adaptor (For units with PX printed on the outer packaging)
(RJP1SG05-Z)
1 AC power supply cord
(RJA0065-1D)
Note
The included AC power supply cord is for use with this unit only. Do not
use it with other equipment.
For U.S.A. and Canada
The remote control
Remote control signal sensor
3
2
1
4
(R6, AA)
g Batteries
• Insert so the poles (+ and –)
match those in the remote
control.
• Do not use rechargeable type
batteries.
g Use
• Aim at the sensor, avoiding obstacles, at a
maximum range of 7 m directly in front of the
unit.
• Operation can be affected by strong light
sources, such as direct sunlight, and the
glass doors on cabinets.
• Never use alcohol, paint thinner or benzine to clean this unit.
• Before using chemically treated cloth, read the instructions that came with the cloth carefully.
(RJA0019-D)
For units with PX printed on the outer packaging