Panasonic SC-HT15 - Manual (Page 4)

4
RQT7
94
9
Spea
ker se
tup
S
tep
1
1
Speaker setup
Step
• To prevent damage or scratches, lay a soft cloth and perform assembly on it.
• For assembly, use a Phillips-head screwdriver.
Front and surround speaker assembly
1
1 3
2
Attach the pipe to the base.
Thread the speaker cable through the base.
• Untie the cable before threading. Secure the pipe to the base.
The supplied stands are specially designed for use with
this unit’s speakers.
Only use as indicated in this setup.
Small screws
(included)
Match the holes.
Insert the pipe.
Ensure the screws are securely fastened by lightly tightening
the left and right side screws alternately until fully tightened.
2
SC-HT17
Attach the stand to the speaker.
Ensure the stand is fastened on straight by lightly tightening the top and bottom
screws alternately until fully tightened.
• There is no difference between the right and left speakers.
You can also attach to the upper rear of the speaker.
Speaker height
Front Speakers
Try to line up the middle of the
speakers with the middle of the
television.
Surround speakers
It is usually better to position the
surround speakers a little higher.
Large screws
(included)
Before attaching, check the speaker label.
• SB-FS930: Use as front speakers. Attach the stands with the short cables.
• SB-FS880: Use as surround speakers. Attach the stands with the long cables.
(x 2) SC-HT17
SC-HT15 SC-HT16
SC-HT17
SC-HT15 SC-HT16 (x 2) (x 2)
(x 4) (x 2) SC-HT17
Supplied
accessories
Speaker stands with long cables Stand bases Speaker stands
SC-HT17PP-EN.fm Page 4 Thursday, March 17, 2005 9:56 AM