ProForm Trainer PFTL39507.1 - Manual (Page 7)

7
4. With the help of a second person, carefully tip
the treadmill down so that the Base (85) is flat on
the floor.
Identify the Right Upright (78) and the Right
Upright Spacer (80), which are marked with
stickers. Insert the Upright Wire (77) through the
Right Upright Spacer as shown.
See the inset drawing. Tie the wire tie in the
Right Upright (78) securely around the end of the
Upright Wire (77). Then, pull the other end of the
wire tie until the Upright Wire is routed com-
pletely through the Right Upright. Make sure that
the Upright Wire does not fall into the Right
Upright.
77
80
Hole
78
85
4
3. With the help of a second person, carefully tip
the treadmill onto its right side. Partially fold the
Frame (48) so that the treadmill is more stable;
do not fully fold the Frame yet.
Attach a Base Pad (81) to the Base (85) in the
location shown with a Base Pad Spacer (71) and
an M4 x 25mm Screw (2). Then, attach another
Base Pad (81) with only an M4 x 25mm Screw
(2).
Attach a Wheel (86) with a M10 x 50mm Bolt
(27) and a M10 Nut (33).
Do not overtighten
the Nut; the Wheel must turn freely.
3
85
86
48
27
33
81
2
81
71
2. Attach a Wheel (86) with a M10 x 50mm Bolt
(27) and a M10 Nut (33). Do not overtighten
the Nut; the Wheel must turn freely.
Cut the tie off the Upright Wire (77).
85
77 Tie
27
33
2
86
2
Wire
Tie
Wire
Tie
77
78