Proxim ORINOCO AP-2000 - Manual (Page 144)

144
Using the Command Line Interface (CLI)
NOTE
Proxim recommends changing your default passwords immediately. To perform this operation using CLI
commands, refer to
Change Passwords .
Set Basic Configuration Parameters using CLI Commands
There are a few basic configuration parameters that you may want to setup right away when you receive the AP. For
example:
– Set System Name, Location and Contact Information
– Set Static IP Address for the AP
– Download an AP Configuration File from your TFTP Server
– Set up Auto Configuration
– Set Network Names for the Wireless Interface
– Enable and Configure TX Power Control for the Wireless Interface(s)
– Configure SSID (Network Name) and VLAN Pairs, and Profiles
– Download an AP Configuration File from your TFTP Server
– Backup your AP Configuration File
Set System Name, Location and Contact Information
[Device-Name]>set sysname <system name> sysloc <Unit Location>
[Device-Name]>set sysctname <Contact Name (person responsible for system)>
[Device-Name]>set sysctphone <Contact Phone Number> sysctemail <Contact E-mail address>
[Device-Name]>show system
Figure A-12 Result of “show system” CLI Command
Set Static IP Address for the AP
NOTE
The IP Subnet Mask of the AP must match your network’s Subnet Mask.
[Device-Name]>set ipaddrtype static
[Device-Name]>set ipaddr <fixed IP address of unit>
[Device-Name]>set ipsubmask <IP Mask>
[Device-Name]>set ipgw <gateway IP address>
[Device-Name]>show network
Change Passwords
[Device-Name]>passwd <Old Password> <New Password> <Confirm Password> (CLI password)
[Device-Name]>set httppasswd <New Password> (HTTP interface password)
[Device-Name]>set snmprpasswd <New Password> (SNMP read password)
[Device-Name]>set snmprwpasswd <New Password> (SNMP read/write)
[Device-Name]>set snmpv3authpasswd <New Password> (SNMPv3 authentication password)