Philips DC350/12 - Manual (Page 18)

English
19 EN
Connect a device for the fi rst time
1
Press BLUETOOTH to select the Bluetooth source.
[BT] (Bluetooth) is displayed.
2
Press and hold PAIRING for more than 3 seconds.
[PAIRING] (Pairing) is displayed, and the Bluetooth indicator blinks.
3
On the device, set up the Bluetooth connection:
a Enable Bluetooth to search for other Bluetooth devices. (Refer to the
user manual on how to enable the function.)
b When “ PHILIPS DC350” is recognized and displayed, select it to start to
connect.
c When prompted for a password, enter “0000”.
4
Wait until you hear a double beep from the DC350.
The connection is complete. The Bluetooth indicator turns on.
To connect more bluetooth devices
1
Disconnect the connected device. (see ‘Disconnect a device’ on page 19 )
2
Repeat the steps 1-4 in “Connect a device for the fi rst time”.
Tip
If no connection is made within one minute, [FAILED] (failed) is displayed on the DC350. •
Disconnect a device
1
Press and hold for more than 5 seconds
[DISCONNECT] (disconnect) is displayed on the DC350.
When you turn off the connected device or move it beyond the
communication range, you hear a long beep from the DC350.
Re-connect a device
After you have connected a device for the fi rst time, once its Bluetooth function is enabled,
it re-connects automatically. (see ‘Connect a device for the fi rst time’ on page 19 )
1
Ensure that on the device, you have turned on the Bluetooth function. (Refer to
the user manual on how to enable the function.)
2
Turn on the DC350.
The Bluetooth connection is automatically made, and the Bluetooth indicator
turns on.
When more than one previously-connected device is in the operational range:
If an iPhone is docked, it is re-connected fi rst.
All other devices are re-connected sequentially: The fi rst device that was
connected for the fi rst time will be re-connected fi rst.
»
»
»
»
•
»
»
DC350_12_Book 1.indd 19 DC350_12_Book 1.indd 19 11/7/2008 2:05:24 PM 11/7/2008 2:05:24 PM