Precor Manual 903 - Manual (Page 6)

page 6
d. Re-insert the bolts and washers as shown in Diagram 2. Tighten the
bolts securely using the hex key provided.
Flywheel
Diagram 2
Installing the Front Lift Bar assembly.
Side rail mount
Running belt
Elevation tube
Diagram 3
Locking handrail into upright position.
Elevation tube
Height adjustment pin
Side rail
Front lift bar
Handrail
Micro adjustment knob
T-knob
Frame plate
2. Position the Handrail. (Diagram 3) Remove the T-knobs and washers
from the hardware kit and take the following steps to secure the handrail:
a. Pull the handrail into an upright position. See Diagram 3.
Important: Perform the remaining steps on one side of the treadmill
at a time.
b. Hold onto the handrail while you insert a T-knob and washer through
the handrail mount (one on each side of the treadmill). Repeat this
step for the opposite side.
c. Align the T-knob with the hole in the side rail and tighten the T-knob
by turning it clockwise. Alternately tighten the T-knobs until both
washers are tight against the side rails.
3. Adjust the incline of the treadmill and set the running belt to the proper
resistance level, by following the steps in
Adjusting the Elevation Tube.
Locking portion of pin
Height adjustment pin
Front lift bar
Washer
Bolt