ProForm 3.8 PATL40707.0 - Manual (Page 9)

9
9. Insert the indicated connectors into the Right
Upright (78).
Next, insert the fronts of the brackets on the
Bridge (95) into the Uprights (74, 78), and then
fully insert the brackets.
Make sure that the
plastic edges of the Bridge (95) are inside the
Uprights. Be careful not to pinch the wires.
Attach the Bridge (95) with six 1/4" x 1/2" Bolts
(7) and six 1/4" Star Washers (10);
start the two
Bolts indicated by the arrows first before
starting the other four Bolts. Tighten all six
Bolts.
See steps 5 and 7. Tighten the four 3/8" x 4 1/2"
Bolts (6).
10
7
95
Connectors
Front
Edge
74
78
10
7
7
7
9
8. Have a second person hold the Bridge (95) near
the Right Upright (78). Remove the wire tie from
the Upright Wire (38).
Connect the Upright Wire (38) to the Bridge Wire
(52).
See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again.
IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS
TURNED ON.
78
95
52
Wire Tie
8
38
38
52