POLAR GPS Sensor G1 - Manual (Page 2)

Wearing Polar G1 Sensor
1. Push to open the clip (Picture 2).
2. Thread the armband loosely through the
loops on the clip and fasten (Picture 3).
You can fasten the sensor on a belt or on
the top of a backpack without the
armband.
3. Position the armband round your upper
arm and fasten (Picture 4). Place the
sensor and the Polar product on the same
arm. Make sure that the "POLAR" logo is
in an upright position.
Turning Polar G1 Sensor On/Off
To best catch satellite signals, go outdoors and
away from tall buildings and trees. Press the
button shortly to turn the sensor on. A flashing
battery indicator led (Picture 5 b) shows the
power mode (low/full). Then a red satellite
indicator led (Picture 5 a) will flash as the
sensor searches for satellite signals. The sensor
will find the signals faster if you keep the
sensor immobile during the search. A green led
will start flashing when the signals are found
and location is determined. Your Polar G1
sensor is now ready for action.
To turn the sensor off, press the button for one
second. The power switches off automatically if
the sensor cannot locate satellite signals or the
sensor location does not change for 15 minutes.
E N G L I S H
2