Pride Mobility Jazzy Select 14 INFINFB2048 User Manual
Page 2
INFINFB2048/Rev A/11-29-06
www.pridemobility.com
2
B
ASIC
T
ROUBLESHOOTING
I
NSTRUCTIONS
: J
AZZY
S
ELECT
14
What if my Jazzy Select 14 begins pulling to one side?
! Determine if the joystick is being deflected straight or at a slight angle. Even a small amount of deflection
right or left will cause the chair to veer over a long distance.
! Determine if both manual freewheel levers are in the drive position. If only one manual freewheel lever is
in the drive position, the other motor will not operate and the Jazzy Select 14 will veer severely.
! Determine if both tires are inflated to the proper psi if the power chair is equipped with pneumatic tires.
Pneumatic tires should be inflated to 35 psi (2.4 bar). If one tire is inflated more than the other, the power chair
will pull to the side that is underinflated.
What if the Jazzy Select 14 powers up, but will not move?
! Determine if both manual freewheel levers are in the freewheel position. If the power chair is in freewheel
mode, then the electronics will function but the motors will not spin the wheels.
! Determine if the controller is flashing a fault code. The Jazzy Select 14 comes equipped with a VSI or VR2
controller. Both controllers will flash a code via the battery condition meter LEDs if a system fault is detected.
VSI DIAGNOSTIC FLASH CODES
# OF LEDS
CODE
CAUSE
POSSIBLE SOLUTION
One red LED
1
Low battery voltage
Charge batteries
Two red LEDs
2
Left motor open
Make sure left motor is plugged into controller.
Three red LEDs
3
Left motor wiring fault
Contact your authorized Pride Provider.
Three red LEDs
4
Right motor open
Make sure right motor is plugged into controller.
One yellow LED
Three red LEDs
5
Right motor wiring fault
Contact your authorized Pride Provider.
Two yellow LEDs
Three red LEDs
6
Inhibit active
Contact your authorized Pride Provider.
Three yellow LEDs
Three red LEDs
7
Joystick error
Contact your authorized Pride Provider.
Four yellow LEDs
Three red LEDs
8
Controller error
Contact your authorized Pride Provider.
Four yellow LEDs
One green LED
Three red LEDs
9
Brake fault
Make sure both motors are plugged into controller.
Four yellow LEDs
Two green LEDs
Three red LEDs
10
High battery voltage
Contact your authorized Pride Provider.
Four yellow LEDs
Three green LEDs