Philips 6FF3FPB - Manual

PhotoFrame Firmware Upgrade Instructions
Applicable models 6FF3FPB, 6FF3FPW
Firmware version 056
Release date October 20, 2008
Release notes - Preloaded baby photo is deletable
!
Important notice before updating
The firmware upgrade process will remove all photos currently stored on PhotoFrame.
Please make sure all photos on PhotoFrame are properly backed up before updating.
!
Please follow the steps below to upgrade the PhotoFrame firmware.
1 Format SD (Secure Digital) card
2 Copy all files from the ‘ Firmware ’ folder into the root folder of the SD card
(The root folder is the ‘highest’ folder in hierarchy, for example F:\ )
3 Make sure PhotoFrame is powered Off
4 Insert SD into PhotoFrame with the new firmware into the PhotoFrame
5 Hold the Menu and Power button for 5 seconds to power on the PhotoFrame
6 The firmware upgrade will start automatically, “ upgrade burning ” shows.
!
Warning: Upgrade takes about 2 minutes.
During the upgrade do not disconnect power, remove the memory or make new
connections. Otherwise this may harm your PhotoFrame.
!
7 When firmware upgrade is complete, PhotoFrame will automatically reboot.
8 Remove the memory from the PhotoFrame
9 The upgrade has completed
You can check the new firmware version via Setup → Status → Firmware .