Philips CD190 - Manual (Page 10)

8 EN
Caution
• Risk of explosion! Keep batteries away from heat,
sunshine or fire. Never discard batteries in fire.
•
Use only the supplied batteries.
•
Risk of decreased battery life! Never mix different
brands or types of batteries.
Note
•
Charge the batteries for 8 hours before first use.
• If the handset becomes warm when the batteries are
being charged, it is normal.
Warning
•
Check the battery polarity when inserting in the
battery compartment. Incorrect polarity may damage
the product.
The batteries are pre-installed in the handset.
Pull the battery tape off from the battery door
before charging.
Configure your phone
(country dependent)
1
When using your phone for the first time,
you see a welcome message.
2
Press MENU/OK.
Set the country/language
Select your country/language, then press
MENU/OK to confirm.
» The country/language setting is saved.
Note
• The country/language setting option is country
dependent. If no welcome message is displayed, it
means the country/language setting is preset for your
country. Then you can set the date and time.
To re-set the language, see the following steps.
1
Select [MENU] > [PHONE SETUP] >
[LANGUAGE], then press MENU/OK to
confirm.
2
Select a language, then press MENU/OK
to confirm.
» The setting is saved.
Set the date and time
Tip
• To set the date and time later, press REDIAL/C to skip
this setting.
1
Press MENU/OK.
2
Select [PHONE SETUP] > [DATE/TIME],
then press MENU/OK to confirm.
3
Press the numeric buttons to enter the
date, then press MENU/OK to confirm.
» The time setting menu is displayed on
the handset.
4
Press the numeric buttons to enter the
time.
• If the time is in 12-hour format, press
/ to select [AM] or [PM].
5
Press MENU/OK to confirm.
Change the remote access
PIN code
Note
• The default answering machine remote access PIN
code is 0000 and it is important to change it to ensure
the security.