Paxar Monarch 9413 - Manual (Page 35)

D e f i n i n g t h e C o n t r o l C h a r a c t e r s P a c k e t
Use the control characters packet (E) to change the MPCLII
control characters, enable and disable the immediate commands,
and change the default terminator character for job requests and
ENQ’s.
Changes take effect with the first character following the end of
header character } of the configuration packet. Each control
character must be unique and cannot appear anywhere else in
your packet, except within quotation marks. You can customize
the trailer characters to work with your host.
Wait two seconds for the new characters to
take effect before sending packets using the
new characters.
Use the following syntax for the control characters packet. Notice
all but the first parameter are within quotation marks.
Syntax { I ,E,"ANSI_cd","string1","string2" p }
E1. E Control Characters Packet
E2. "ANSI_cd" ~123 Start of header { (left bracket)
~044 Parameter , (comma)
separator
~034 Quoted strings " (quotes)
~124 Field separator p (pipe sign)
~125 End of header } (right bracket)
~126 Data escape ~~ (double tilde)
character (optional)
def. ch. Immediate command character (optional).
Up to any 3 digits in the 0 to 255 decimal
range. The tilde (~) must be used with decimal
characters. The character must be defined before
this command can be used. The caret (~094) is
normally used.
NOTE: "ANSI_cd" includes seven separate parameters. The
first five parameters are required. The other
parameters are optional.
Configuring the Printer 3-13