Premier Mounts AM250-FLIP - Manual (Page 6)

Page 6 Installation Instructions
AM250
Thread Depth Indicator
Step 1. Insert the thread depth indicator (supplied) through the thread inserts found on the back of the flat panel to make sure
the inserts measure the same full depth and mark it (Figure 1).
Step 2. Locate the correct diameter screw for the thread insert. Compare your marking to the screws (supplied).
Step 3. If your selected screw is longer than the marking on the thread depth indicator, DO NOT USE this screw.
Step 4. The screw length must not bypass the marking. Select another screw size (Figure 2 and 3), until you find one that comes
closest to your mark without going past.
Figure 1
Figure 2
Figure 3
Thread Depth
Indicator
Marking Screw
Marking
Screw
Thread Depth
Indicator
Inverted Flat
Panel Display
Marking the
Depth
Thread Insert
Thread Depth
Indicator