ParaBody 823 - Manual (Page 4)

4
PARTS LIST
PART #
6416010
6125101
6194601
KEY
1
2
3
QTY
1
2
4
PART #
3105401
6236701
DESCRIPTION QTY
4
2
DESCRIPTION
LEG HOLD DOWN FRAME
ROLLER PAD SHAFT
ROLLER PAD
KEY
4
5
* Using rubber mallet or hammer gently tap the four STARLOCK COLLAR (4) to the ends of
each ROLLER PAD SHAFT (2)
* Insert two CAP END (5) into both ends of the LEG HOLD DOWN (1) as shown in figure 1.
* To perform DECLINES or AB CRUNCHES, insert the LEG HOLD DOWN ASSEMBLY into
the UPRIGHT TUBE of the BENCH FRAME as shown in FIGURE 1, and tighten in place
using the THUMBSCREW. To adjust the SEAT PAD for the DECLINE position, pull out on
the U-PIN. Rotate the U-PIN back pass the FIRST PIN STOP. Release the U-PIN, and allow
it to rest up against the SECOND PIN STOP.
* Assemble four ROLLER PAD (3) to the LEG HOLD DOWN (1) as shown, using two ROLLER
PAD SHAFTS (2).
5
2
1
3
4
STEP 1:
FIGURE 1
PIN STOP
U-PIN
UPRIGHT TUBE,
BENCH FRAME
LEA
LEA
LEA
LEA
LEA
1-3/4 IN. SQ. END CAP
STARLOCK COLLAR