Philips FLAT TV 42PFL7803D - Manual (Page 25)

EN-25
Install channels 6.
Automatically install 6.1
channels
Press 1. SOURCE and Î or ï to select
TV from the source list.
Press 2. ANALOG MENU to display the
on-screen menu.
Select 3. Install > Auto Program and
press OK.
Auto Program
Program 3
TV 196 MHz
Auto Program starts scanning for
channels automatically. When scanning
is complete, the first installed channel is
displayed.
Press 4. Í to return to the previous menu
or press ANALOG MENU to exit.
Tip E : To cancel or interrupt auto search-
ing, press ANALOG MENU. Only chan-
nels found before interruption are stored.
Manually install channels 6.2
Manually set the TV tuner and system and
fine tune the channels.
Change the Tuner Mode
Manually set the tuner system if you have
problems using Auto Program to search
for channels.
Press 1. SOURCE and Î or ï to select
TV from the source list.
Press 2. ANALOG MENU to display the
on-screen menu.
Select 3. Install > Tuner Mode and press
OK.
Press 4. ï or Î to select Auto, Antenna
or Cable, and press OK to select.
Install
Tuner Mode
Auto Program
Manual
Name
Fav. Program
Auto
Antenna
Cable
Press 5. Í to return to the previous menu
or press ANALOG MENU to exit.
Tuner Modes
Auto • : Automatically detects if the cable
signal input is present.
Antenna • : Detects antenna signals and
searches for all antenna TV channels
available in your local area.
Cable • : Detects cable signals and
searches for all cable TV channels
available in your local area.
Change the TV System
Press 1. SOURCE and Î or ï to select
TV from the source list.
Press 2. ANALOG MENU to display the
on-screen menu.
Select 3. Install > Manual > System, and
press OK.
Press 4. ï or Î to select Auto, NTSC,
PAL-M or PAL-N, and press OK to
select.