Pride Mobility Controller Flight - Manual (Page 13)

Basic Operation Instructions 13
www.pridemobility.com FLIGHT Controller
OFF-BOARD CHARGER/PROGRAMMING SOCKET
You may use an off-board charger to charge the power chair batteries through the
3-pin socket located on the front of the FLIGHT. If you use an off-board charger,
the charger current should not exceed 8 amps. Contact your authorized Pride
Provider for more information.
WARNING! Only chargers with Neutrik NC3MX plugs should
be connected to the off-board charger/programming socket.
See your authorized Pride Provider for more information.
NOTE: The socket may also be used for reprogramming the FLIGHT.
Contact your authorized Pride Provider for more information.
LOCK MODE
The Flight controller is equipped with a feature that enables you to “lockout”
unauthorized users.
To lock the FLIGHT controller:
1. While the power is on, press and hold the on/off key for 2 seconds. The
display will turn off immediately. After 2 seconds, all LEDs will flash briefly
and the horn will sound a short beep.
2. The FLIGHT controller is now locked.
To unlock the FLIGHT controller:
1. While the FLIGHT is locked, press the on/off key to turn on the FLIGHT. All
LEDs will flash briefly. The LEDs will then slowly ripple from right to left.
2. Press the horn key twice before the LED ripple has completed, approximately
10 seconds. The FLIGHT is now unlocked.
SLEEP MODE (IF ENABLED)
The power chair controller features a sleep mode. Sleep mode is a built-in circuit
that will automatically shut off the main power if the joystick is not moved in any
direction for a period of time. This time factor is programmed into the controller.
To restore power and continue, push any key on the keypad.