Use now, Power on / off, Turning the power on and off – Panasonic PT-56LCX16 User Manual

Page 24

Advertising
background image

For assistance, please call : 1-888-VIEW PTV(843-9788) or, contact us via the web at: http://www.panasonic.com/contactinfo

24

Always be sure to follow the procedure given below to
turn the Projection Display power ON and OFF.

• The lamp cooling fan will continue to operate for

approximately 1 minute after the power is turned off. During
this time, the POWER indicator will blink Red.

Press POWER on Projection Display or Remote Control
to turn power on.
The Power Indicator blinks Green for about 20 seconds
and then turns solid Green.

The Power Indicator

Notes:

• If the POWER button is accidentally turned off during use,

after power is turned back on, it may take a short period
before the lamp automatically comes on.

• After the unit is turned on, maximum picture brightness will be

achieved in 5-10 minutes. This is normal.

• This unit consumes approx. 0.4 W in OFF condition when

plugged into an AC outlet.

Press POWER on Projection Display or Remote Control
to turn power off.

Note:

• When the power cord is disconnected, the internal cooling

fan stops op er at ing. In this case, the lamp will be insufficiently
cooled and will take a while to turn ON again.

Power ON

Power OFF

The Power Indicator blinks Red for about 1 minute and
then LED turns off.

Turning the Power ON and OFF

LED

ACTION

Off

Power – OFF

Red (blinking)

Power – OFF (Now cooling)

Green

Power – ON

Green (blinking) Power – ON (Preparing to light lamp)

Power shuts off after a Black Screen is displayed for a
few seconds.
Note:

• If the POWER button is pressed during the Black Screen

display, Power is turned back on.

Do not disconnect the power cord from the outlet
and do not open the circuit breaker (unless
necessary) while the cooling fan is still operating. Do
not disconnect the power cord from the power outlet
while the power indicator blinks Red.

Power ON / OFF

Auto shut off

To conserve lamp life, if there is no signal to the
set’s tuner for 5 minutes, the lamp will shut off
automatically.

POWER button/
POWER indicator

Advertising
This manual is related to the following products: