Philips DCB293 - Manual (Page 15)

16
2
Press PROG/CLOCK SET to activate
program mode.
3
Press / to allocate a number to
this radio station, then press and hold
PROG/CLOCK SET
WRFRQÀUP
4
Repeat the above steps to program other
stations.
Tip
To overwrite a programmed station, store ‡
another station in its place.
Select a preset radio station
1
In tuner mode, press / to select a
preset number.
2
Press /ENTER WRFRQÀUP
You can also press the numeric buttons ‡
to select a preset number directly.
You can press
‡ /ENTER to switch
between mono and stereo signals.
Tip
Position the antenna as far as possible from ‡
TV, VCR or other radiation source.
For optimal reception, fully extend and adjust
‡
the position of the antenna.
FM stations with RDS
Radio Data System (RDS) is a service that
sends additional broadcast information along
with FM stations.
If you listen to a FM station with RDS signal,
“RDS” is displayed.
Display RDS information
1
For an FM station with RDS, press
RDS/DISPLAY repeatedly to display
various broadcast information.
4
Press / to switch to [Tuner Reset].
5
Press ENTER WRFRQÀUP
6
Press / to switch between [Y] and
[N].
‡
[Y]: reset all DAB/FM radio stations.
‡ [N]: preset radio stations remain
unchanged.
7
Press ENTER WRFRQÀUP
Listen to FM radio
Tune to a radio station
1
Press TUNER to select FM.
2
Press / WRWXQHWRDVSHFLÀF
frequency.
Play starts automatically.
»
Tip
You can press ‡ MODE/SCAN to tune to
the next station with strong reception
automatically.
Program radio stations automatically
You can program a maximum of 30 preset
radio stations (FM).
1
In the tuner mode, press and hold
MODE/SCAN to activate automatic
program mode.
All available stations are programmed
»
in the order of waveband reception
strength.
7KHÀUVWSURJUDPPHGUDGLRVWDWLRQLV
»
broadcast automatically.
Program radio stations manually
You can program a maximum of 30 preset
radio stations (FM).
1
Tune to a radio station.
EN