Python 240-8XX 091-0593 - Manual (Page 7)

Millermatic Python ® Owner's Manual Page iii
OM-1594 Page 3
1-3. Additional Symbols for Installation, Operation, And Maintenance
fIRE OR EXPLOSION hazard.
� Do not install or place unit on, over, or near
combustible surfaces.
� Do not install unit near flammables.
� Do not overload building wiring – be sure power supply system is
properly sized, rated, and protected to handle this unit.
fALLING UNIT can cause injury.
� Use lifting eye to lift unit only, NOT running
gear, gas cylinders, or any other accessories.
� Use equipment of adequate capacity to lift and
support unit.
� If using lift forks to move unit, be sure forks are
long enough to extend beyond opposite side of
unit.
OVERUSE can cause OVERHEATING
� Allow cooling period; follow rated duty cycle.
� Reduce current or reduce duty cycle before
starting to weld again.
� Do not block or filter airflow to unit.
STATIC (ESD) can damage PC boards.
� Put on grounded wrist strap BEFORE handling
boards or parts.
� Use proper static-proof bags and boxes to
store, move, or ship PC boards.
MOVING PARTS can cause injury.
� Keep away from moving parts.
� Keep away from pinch points such as drive
rolls.
WELDING WIRE can cause injury.
� Do not press gun trigger until instructed to do
so.
� Do not point gun toward any part of the body,
other people, or any metal when threading
welding wire.
MOVING PARTS can cause injury.
� Keep away from moving parts such as fans.
� Keep all doors, panels, covers, and guards
closed and securely in place.
H.f. RADIATION can cause interference.
� High-frequency (H.F.) can interfere with radio
navigation, safety services, computers, and
communications equipment.
� Have only qualified persons familiar with
electronic equipment perform this installation.
� The user is responsible for having a qualified electrician prompt-
ly correct any interference problem resulting from the installa-
tion.
� If notified by the FCC about interference, stop using the
equipment at once.
� Have the installation regularly checked and maintained.
� Keep high-frequency source doors and panels tightly shut, keep
spark gaps at correct setting, and use grounding and shielding to
minimize the possibility of interference.
ARC WELDING can cause interference.
� Electromagnetic energy can interfere with
sensitive electronic equipment such as
computers and computer-driven equipment
such as robots.
� Be sure all equipment in the welding area is
electromagnetically compatible.
� To reduce possible interference, keep weld cables as short as
possible, close together, and down low, such as on the floor.
� Locate welding operation 100 meters from any sensitive elec-
tronic equipment.
� Be sure this welding machine is installed and grounded
according to this manual.
� If interference still occurs, the user must take extra measures
such as moving the welding machine, using shielded cables,
using line filters, or shielding the work area.