Panasonic AK-HC910L - Manual (Page 10)

- 10 -
YPbPr
D-sub 15-pin
D-sub 15-pin
How to Set Up the System (Connection)
_
Connection of remote control box
• Use multi-cable for the connection of Camera Controller AK-HRP900L and this unit.
HD-SDI
Multi-cable (5m)
AK-HDMLTCA05
Coaxial Cable
(5C-FB)
HD Monitor
1 Before connecting the cables, be sure to set the Power Switch of AC Adapter and
Camera Controller to OFF.
2 Connect the multi-cable to the interface connector of the camera, and the opposite side
to Camera Controller.
3 Set the AC Adapter Power Switch to ON, and the Camera Controller Power Switch to
ON, then the camera can be controlled.
4 After shooting, set the Camera Controller Power Switch to OFF, and the AC Adapter
Power Switch to OFF.
Note that the monitor output is
attenuated and deteriorated if
the cable is too long.
External
sync
signal
(3 value
sync)
Video
Input
Signal
AC adapter
AW-PS505A
DC Power
Cable
Camera Controller
AK-HRP900L
NOTE
HD Monitor
Multi-purpose
Digital Camera
AK-HC910L