Philips FM02SW31 - Manual (Page 2)

Note
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one
or more of the following measures:
• reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
The shielded interface cable and connectors must be used in order
to comply with the limits for digital device pursuant to subpart B
of Part 15 of FCC rules.
Electric-, Magnetic- and Electromagnetic Fields (EMF)
1 Philips royal electronics manufactures and sells many products
targeted at consumers, which, like any electronic apparatus, in general
have the ability to emit and receive electro magnetic signals.
2 one of Philips’ leading Business Principles is to take all necessary
health and safety measures for our products, to comply with all
applicable legal requirements and to stay well within the emF
standards applicable at the time of producing products.
3 Philips is committed to develop, produce and market products that
cause no adverse health effects.
4 Philips confirms that if its products are handled properly for their
intended use, they are safe to use according to scientific evidence
available today.
5 Philips plays an active role in the development of international emF
and safety standards, enabling Philips to anticipate further
developments in standardization for early integration in its products.
Specifications are subject to change without prior notice. “Active
Crystals”, “Philips” and “Swarovski” are registered trademarks and
are the property of koninklijke Philips electronics N.V. (and/or their
respective owners) and/or Swarovski AG. © 2008 koninklijke Philips
electronics N.V. and Swarovski AG. All rights reserved.