Safety and maintenance, Troubleshooting – Philips AJ260 User Manual

Page 9

Advertising
background image

Safety and general
maintenance

•

If you do not intend to use the clock radio
for a long time, withdraw the power cord
from the wall outlet.

•

Place the set on a hard and flat surface so
that the system does not tilt.

•

Install the unit near the AC outlet and where
the AC power plug can be easily reached.

•

The apparatus shall not be exposed to
dripping or splashing.

•

The apparatus shall not be exposed to
dripping or splashing.

•

Do not expose the set, batteries, to humidity,
rain, sand or excessive heat caused by heating
equipment or direct sunlight.

•

No objects filled with liquids, such as vases,
shall be placed on the appartus.

•

No naked flame sources, such as lighted
candles, should be placed on the apparatus.

•

Do not cover the set. Adequate ventilation
with a minimum gap of 6 inches between the
ventilation holes and surrounding surfaces is
necessary to prevent heat build-up.

•

The mechanical parts of the set contain
self-lubricating bearings and must not be
oiled or lubricated.

•

To clean the set, use a soft dry cloth. Do not
use any cleaning agents containing alcohol,
ammonia, benzene or abrasives as these may
harm the housing.

Safety and maintenance

No sound.

– Volume not adjusted.
• Adjust the VOLUME.

Display error / no reaction to any
controls.

– Electrical malfunction
• Press RESET hole on the bottom of the set with

a ball pen.

Occasional crackling sound during FM
broadcast.

– Weak signal.
• Extend the pigtail antenna fully.

The alarm does not function.

– Alarm time not set.
• See section on Setting alarm time.
– Alarm mode not selected.
• See section on Setting alarm mode.
– Volume too low for radio.
• Increase the volume.

The main unit cannot read or update out-
door temperatuare from the sensor

– No signal or weak signal.
• Reset both the main unit and the sensor. Or

improve the sensor reception. See “ Using the
sensor to detect outdoor temperature
”.

Troubleshooting

If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or
service center.

WARNING:

Do not open the set as there is a risk of electric shock. Under no circum-

stances should you try to repair the set yourself, as this will invalidate the warranty.

CCR_AJ260_79_UM_V1.0 7/29/10 13:57 Page 9

Advertising