Parkside XQ2 SE - Manual (Page 9)

10 GB/IE/CY
Preparing for use / Maintenance and cleaning / Disposal / Information
Note! Always switch on the delta sander before
bringing it into contact with the workpiece material.
Switching on the device:
j Move the ON / OFF switch 8 downwards
into the “ON” position.
Switching off the device:
j Move the ON / OFF switch 8 upwards into
the “OFF” position.
Q Vacuum dust extraction
WarNING! DaNGEr oF FIrE! There is
the danger of fire when working with electrical
devices that have a dust box or can be connected
to a vacuum cleaner. Under certain conditions the
wood dust in the dust extraction bag (or in the
vacuum‘s dust bag) may ignite, e.g. as a result of
flying sparks generated when abrading metals or
metal objects left in wood. This can happen partic-
ularly if the wood dust is mixed with paint residue
or other chemicals and the abraded particles are
hot from prolonged abrasion. Therefore you must
empty the device’s dust collection box and the
vacuum cleaner’s dust bag before taking a break
or stopping work and always avoid overheating of
the abraded particles and the device.
Wear a dust mask!
WarNING! Always pull the mains plug is
out of the socket before doing any work on the
device.
Q Dust box for internal
vacuum extraction
Connection:
j
Push the dust box for internal vacuum extraction
4 on to the hand-held sander until it engages.
removal:
j
Press the release button 5 of the dust extraction
box for internal vacuum extraction 4 and
withdraw it towards the rear of the device.
Q reducer piece
Connection:
j Push the reducer piece 3 into the adapter
port 2 .
j
Push the hose of a suitable dust extraction de-
vice approved for that purpose (e.g. a workshop
vacuum cleaner) on to the reducer piece
3 .
removal:
j Pull the dust extraction device hose off the
reducer piece 3 .
j Pull off the reducer piece 3 .
Q attaching / detaching
sanding sheets
WarNING! Always pull the mains plug is out
of the socket before doing any work on the device.
attaching:
j Sanding sheets are attached to the backing plate
7 by means of the hook and pile fastening.
Detaching:
j
Simply pull the sanding sheet off the backing
plate
7 (see Fig. C).
Q rotating the backing plate
WarNING! Always pull the mains plug is out
of the socket before doing any work on the device.
j Rotate the backing plate 7 into the desired
position (see Fig. D).
Sanding and surfaces:
The sanding output and the quality of the surface
finish are determined by the grade of grit on the
sanding sheet.
Preparing for use
XQ2_Handschleifer_Content_LB6.indd 10 19.03.09 14:37