Pride Mobility PRIDE LX12 - Manual (Page 31)

31 AUS Pride LX Series/RevC/Apr03
I X . C A R E A N D M A I N T E N A N C E
n Ensure that all parts of the controller system are securely fastened to your power chair. Do not overtighten any
screws.
n Check for proper tyre inflation. There should be 2-2.4 bar/30 – 35 psi in each pneumatic tyre. If a tyre does not
hold air, see an authorised Pride Provider for replacement.
n Calibrate the joystick if you detect a noticeable difference in performance or if the joystick does not operate
properly. To calibrate the joystick, power off the unit, place the joystick in the neutral position, and power the
unit back on. If a problem still exists with your joystick’s performance, contact your authorised Pride
Provider.
n Check the brakes. This test should be carried out on a level surface with at least three feet of clearance around
your power chair.
To check the brakes:
1. Turn on the controller and turn down the speed of your power chair to the lowest setting.
2. After one second, check the battery condition meter. Make sure that it remains on.
3. Slowly push the joystick forward until you hear the electric brakes click. Immediately release the joystick. You
must be able to hear each electrical brake operating within a few seconds of joystick movement. Repeat this
testthree times, pushing the joystick rearwards, then left, and then right.
Monthly Checks
n Check for extreme wear on the anti-tip wheels. Replace them as necessary.
n Check for drive tyre wear. See an authorised Pride Provider for repair.
n Check the casters for wear. Replace them as necessary.
n Check the rear forks for damage or fluttering which indicates that they may need to be adjusted or have the
bearings replaced. See an authorised Pride Provider for repair.
n Keep your power chair clean and free of foreign material, such as mud, dirt, hair, food, and drink, etc.
Yearly Checks
Take your power chair to an authorised Pride Provider for yearly maintenance. This helps ensure that your power
chair is functioning properly and helps prevent future complications.
Storage
Your power chair should be stored in a dry place, free from temperature extremes. When storing, disconnect the
batteries from the power chair. See VII. “Batteries and Charging.”
WARNING! If you fail to store the unit properly, the frame can rust and the electronics can be
damaged.