Precor p20 - Manual (Page 69)

Assembling the EFX
19
2. Thread the cable through the left upright support. Tape it
to the top of the upright support to secure it temporarily.
Important: Do not stretch, crimp, or damage the cable.
Cables damaged by improper installation will not be covered
by the Precor Limited Warranty.
Figure 3: Thread cable through upright support
3. Attach the left upright support to the base frame using
four buttonhead screws, four split washers, and four
⁵₁₆
-inch washers. Partially tighten the fasteners.
Figure 4: Attach the upright support to the base frame
4. Repeat steps 2 through 4 to attach the right upright
support.
5. Using a right-angle ³₁₆" hex wrench, remove the four ¹₄" x
³₄
" buttonhead screws securing the central plastic base
cover.
6. Remove the tape at the top of the left upright support.