Panasonic KX-FLM671 - Manual (Page 17)

2. Preparation
17 For assistance, please visit http://www.panasonic.com/help
2 Preparation 2For assistance, please visit http://www.panasonic.com/help Connections and Setup
2.1 Connections
Caution:
L When you operate this product, the power outlet
should be near the product and easily
accessible.
*1 KX-FLM671 only
* The pictured model is KX-FLM671.
Note:
L If any other device is connected to the same
telephone line, this unit may disturb the network
condition of the device.
Using surge protectors
L The warranty does not cover damage due to power
line surges or lightning. For additional protection, we
recommend using a surge protector (
9).
If the unit shares a single telephone line with a DSL
service (KX-FLM671 only)
Fax transmission/reception may be unreliable, noise
interference may be heard during telephone
conversations, or Caller ID (page 46) may not function
properly. Please attach a DSL filter (
j) to the telephone
line cord of the unit to prevent this. A DSL filter may be
available from your DSL service provider.
* The pictured model is KX-FLM671.
Using network router/network hub
L We recommend using network routers/network hubs
(
6) under secure network environments. Consult
your network administrator for firewall settings, etc.
L The warranty does not cover damage due to security
problems or any inconveniences relating to it.
1 Power cord
L Connect to a power outlet
(120 V, 60 Hz).
2 Telephone line cord
L Connect to a single telephone line jack (RJ11C).
3 [EXT] jack
L You can connect an answering machine or an
extension telephone. Remove the protective
sheet if attached.
4 Answering machine (not supplied)
5 LAN interface connector *1
L Remove the protective sheet if attached.
6 Network router/Network hub (not supplied) *1
L Also connect networked computers.
7 To the Internet *1
8 LAN cable (not supplied) *1
L To assure continued emission limit compliance,
use only shielded LAN cable (Category 5 (Cat-5)
Ethernet cable).
9
7
1
4
2
8
6
3 5
IMPORTANT NOTICE FOR THE USB
CONNECTION
L DO NOT CONNECT THE USB CABLE UNTIL
PROMPTED TO DO SO DURING THE SETUP
OF MULTI-FUNCTION STATION (page 23).
j