Panasonic WV-CS564 - Manual (Page 14)

15
(6) White Balance (WHITE BAL)
You can select one of two modes for white balance adjustment as follows:
• Auto-Tracing White Balance (ATW)
In this mode, the color temperature is monitored continuously and thereby white balance is set auto-
matically. The color temperature range for the proper white balance is approx.2 600 - 6 000 K. Proper
white balance may not be obtained under the following conditions:
1. The color temperature is out of the 2 600 - 6 000 K range.
2. When the scene contains mostly high color temperature (bluish) objects, such as a blue sky.
3. When the scene is dim.
In these cases, select the AWC mode.
• Automatic White Balance (AWC)
In this mode, accurate white balance is obtained within a color temperature range of approx. 2 300 -
10 000 K.
See page 34 for the setting.
(7) Auto Focus (AF MODE)
The camera adjusts the focus automatically by sensing sharpness in the center of the picture. S, M
and L stand for the breadth of the sensing area: Small, Middle and Large.
See page 36 for details.
MANUAL S, M, L: Auto-focus is activated when the AF key on the controller is pressed.
AUTO S, M, L: Auto-focus is activated automatically while operating manually: pan, tilt or zoom.
(8) Electronic Zoom (EL-ZOOM)
Up to 2-fold electronic zooming is available besides 18-fold optical zooming.
(9) Image Hold (IMAGE HOLD)
The camera picture remains a still image on the monitor screen until the camera reaches the preset
position. This function is useful for surveillance via a local area network.
(10) Special Menu (SPECIAL)
This menu allows you to adjust and set up the following items and functions: chroma level, aperture
level, pedestal level, hue adjustment and refresh function.
You can also reset your parameters to the values preset at the factory.
See page 38 for the setting.
● RS485 communication
Camera communication parameters
See the following items pages for the setting.
• Full/Half duplex (page 46)
• Transmission Speed (2 400 - 19 200 bps) (page 40)
• Parity bit, Stop bit, Flow control (pages 40 and 41)
• Wait time, Delay time (page 41)
• Camera units (96 units max.) (page 44)
• Termination ON/OFF (page 46)
• Reset parameters (page 43)