Pioneer TAD M600 - Manual (Page 11)

11
TAD-M600
Bi-wire connection
The bi-wire connection uses two speaker cables on one amplifier to connect to the speaker’s low-frequency input terminal
and high-frequency input terminal.
In order to connect speakers to this unit using a bi-wire connection, the speakers must be bi-wiring compliant. Align the High
and Low wires correctly to connect.
[An example of connections made to a speaker system with bi-wire connection terminals]
TAD-M600 TAD-M600
INPUT
(BALANCED)
SPEAKERS A B
INPUT
(BALANCED)
SPEAKERS A B
CLASS 2 WIRING CLASS 2 WIRING
High
Low
 
High
Low
 
To balance output terminal To balance output terminal
Pre-Amplifier
Rear side of bi-wiring
compliant speakers
Rear side of bi-wiring
compliant speakers
Note
SPEAKERS A terminals and SPEAKERS B terminals produce the same output. High and Low connectors can be made to
either terminals A or B.
CAUTION
When using bi-wire connections, make sure to remove the short bar connectors on the High-Low terminals of the '
speakers to prevent negative effects on the amplifier. Refer to the operating instructions of your speaker system for further
information.