Panasonic SH-MZ1200 - Manual (Page 7)

RQT7230
7
Connections
Connect the various equipment to the DJ mixer using stereo connection cables, connection cables and appropriate cables (Each sold separately).
When connecting, make sure to turn all equipment power off.
Connection to the XLR terminals
•Open the terminal cover, align the polarities on the XLR plug
(not included) and XLR terminal and insert the plug until it locks.
•To remove the XLR plug, press the knob on the top of the
plug and remove it.
•After removing it, press the center of the terminal cover and
close firmly.
When using a monaural input effector
•Connect to the R/MONO terminal.
•The mixed left (L) and right (R) signal is output to the effector, and the left (L) and right (R) signal from the effector is input.
When listening with headphones
•Turn down the volume using the MONITOR LEVEL control knob before connecting.
•Avoid listening for prolonged periods of time to prevent hearing damage.
Speakers
(Not included)
Monitor amplifier
(Not included)
Speakers
(Not included)
Amplifier
(Not included)
Speakers
(Not included)
Amplifier
(Not included)
Rear panel
Connect when using an amplifier that
has XLR terminals. Terminal polarity is
indicated in the diagram below.
Cold (–)
Hot (+) Ground
Amplifier
(Not included)
(XLR terminal
compatible)
Speakers
(Not included)
Cassette deck (Not included)
Connection
cable
(Not included)
Type:
RCA coaxial
AV Control Receiver
(Not included)
Effector (Not included)
Connect if you want to use an
external effector or sampler etc.
to adjust the sound.
Type:
6.3 mm
(1/4 in.)
monaural
Front panel
Type:
6.3 mm (1/4 in.)
stereo
Headphone
(Not included)
Output side connections
Stereo connection cables
White (L)
Red (R)