Philips 32PFL5203 - Manual (Page 22)

EN-20
mode) or Mono or Spatial (when in
mono mode).
BBE • (High definition sound)
An enhancement technology licensed
by BBE Sound. Restores clarity and
presence for better speech intelligibility
and musical realism.
Adjust Ambilight settings 5.4
This feature is not available on all models.
1. Press MENU on the remote control and
select Ambilight.
Press
2. Æ to enter the list.
Main
Picture Setting
Advanced Picture
Sound
Ambilight
Features
Install
Location
Ambilight
Brightness
Mode
Colour
Custom colour
Balance
Press 3. Î or ï to select one of the following
settings:
Ambilight •
Switches Ambilight on or off.
• Brightness
Changes the light output of Ambilight.
• Mode
Chooses from four Ambilight modes:
Colour, Relaxed, Moderate, and Dynamic.
• Colour
Selects a pre-defined colour setting
(Warm white, Cool white, Blue, Red,
Green, Yellow, Magenta, or make a
custom colour of your own.
Note D
This option appears only after you select
Mode >Colour above.
Custom Colour •
Sets the colour saturation or palette.
Note D
This option appears only after you select
Colour > Custom above.
• Balance
Sets the level of Ambilight on the left
and right side of the TV.
Caution C
To avoid poor remote control reception, do
not place remote control sensors on your
devices in range of Ambilight.
Use advanced teletext 5.5
features
Depending on model, your TV has a 1,000 or
1,200 page memory that stores broadcasted
teletext pages and sub pages. The teletext
memory reduces page loading time.
To select a teletext page, see Section 4.4 Use
teletext.
Select teletext sub pages 5.5.1.
A teletext page can hold several sub pages. Sub
pages are displayed on a bar next to the main
page number.
Press 1. ¤ on the remote control.
Select a teletext page. 2.
Press 3. Í or Æ to select a subpage.
Select T.O.P. teletext broadcasts 5.5.2.
Table Of Pages (T.O.P.) teletext broadcasts
allow you to jump from one subject to another
without using page numbers. T.O.P. teletext is
not broadcast on all TV channels.
Press 1. ¤ on the remote control.
Press 2. STATUS/EXIT.