Pioneer 7.1 VSX-AX2AV-S - Manual (Page 51)

Other connections 08
51
En
Connecting the multichannel analog inputs
For DVD Audio and SACD playback, your DVD player may
have 5.1, 6.1 or 7.1 channel analog outputs (depending
on whether your player supports surround back
channels).
1
Make sure that the player is set to output
multichannel analog audio.
1 Connect the front, surround, center and subwoofer
outputs on your DVD player to the corresponding
MULTI CH input jack on this receiver.
• Use standard RCA/phono jack cables for the
connections.
2 If your DVD player also has outputs for surround
back channels, connect these to the corresponding
MULTI CH input jacks on this receiver.
• Use standard RCA/phono jack cables for the
connections.
• If there is a single surround back output, connect it to
the SURROUND BACK L (Single) jack on this
receiver.
Selecting the multichannel analog inputs
If you have connected a decoder or a DVD player as
above, you must select the analog multichannel inputs
for surround sound playback.
2
1 Make sure you have set the playback source to the
proper output setting.
For example, you might need to set your DVD player to
output multichannel analog audio.
2 Use the INPUT SELECT button to select MULTI CH IN.
You can also use the INPUT SELECTOR dial on the front
panel.
• Depending on the DVD player you’re using, the
analog output level of the subwoofer channel may be
too low. In this case switch the receiver into standby,
then press
STANDBY/ON while holding down
VIDEO SELECT on the front panel. This switches
between SW IN +10dB (increase of 10 decibels) and
SW IN 0dB (default) in the subwoofer channel.
Using the USB interface
VSX-AX4AVi only
It is possible to listen to two channels of audio from your
computer by connecting to the USB interface on the rear
of this receiver. Depending on your model of computer
and the software installed, you can listen to the stereo
audio source through the speaker setup you’ve
connected to this receiver.
3
1 Connect your computer’s USB terminal to the USB
terminal on the rear panel of this receiver.
2 Switch on your computer and this receiver.
Note
1 To listen to multichannel analog audio you’ll need to switch the input signal selector to MULTI CH INPUT (see Selecting the multichannel analog inputs
above for more on this).
2 • When playback from the multichannel inputs is selected, you can’t use Midnight/Loudness, Dialog Enhancement or the
SIGNAL SELECT and ANA-
LOG ATT buttons, as well as any of the listening modes (including STEREO and the surround back channel processing).
• When playback from the multichannel inputs is selected, only the volume and channel levels can be set.
• You can’t listen to your speaker B (Second Zone) system during playback from the multichannel inputs.
RECEIVER SOURCE
SYSTEM OFF
INPUT
SELECT
DVD SAT VIDEO 1 TV CONT
CD TV VIDEO 2
3 • Windows ® XP, Windows ® 2000, Windows ® Millennium Edition and Windows ® 98 Second Edition operating systems have been tested for compatibility
with this interface, but depending on your computer setup, you may find that your system is not compatible.
• Make sure you use a USB cable that connects from an A-type connector (from your PC) to a 4-pin B-type connector (to the receiver).
• The USB specification is version 1.1 compatible, and the USB Audio Class specification is 1.0 compatible.
• Any computer alert sounds will also be heard through the speakers unless you switch them off from the computer’s control panel.
• You won’t be able to hear the audio from the USB connection through the digital outputs of this receiver.
• Note that using hubs or extensions may cause connection problems.
S400
(AUDIO)
S400
MULTI-ROOM &SOURCE /REC SEL OUT1 ROOM3(ZONE3)
OUT2
USB
AUDIO
IN
IN 1
(SAT)
IN 2
(DVR/
VCR 1)
IN 3
(DVR/
VCR 2)
IN
4
(CD-R)
1–2
1–3
1–4
IN 1
(DVD/
LD) IN 2
IN 1(DVD/LD)
IN 2(TV)
IN 1
IN 1
IN 2
IN 3 IN 3
OUT
MULTI-ROOM & SOURCE
MULTI-ROOM & SOURCE
MONITOR OUT
12 V TRIGGER
ROOM2(ZONE2) ROOM2(ZONE2)
FM UNBAL 75 Ω AM LOOP
MONITOR OUT
OUT
CD
CD-R/ TAPE
DVD/ LD
TV
SAT
VIDEO1/
GAME1
OUT
DVR/ VCR 1
DVR/ VCR 2
OUT
IN
IN
IN
VIDEO
VIDEO AUDIO
S - VIDEO
IN
IN
IN
FR FL
SUB W. CENTER
MULTI CH
IN
RS-232C
SUR- ROUND
SURROUND BACK
CONTROL
iPod
SUB W.
F
C
OUT
PHONO
IN
IN
IN
IN
ROOM2
(ZONE2)
IN
(DC OUT 12V TOTAL 50mA MAX)
1 2
IN 2
(CD)
IN1
IN2
OUT Y
P B
P R
Y
P B
P R
Y
P B
P R
Y
P B
P R
DIGITAL COMPONENT VIDEO
ASSIGNABLE
ASSIGNA-
BLE
1–2
ASSIGNABLE
OUT
IN OUT
ANTENNA AUDIO PRE OUT
MULTI-ROOM & SOURCE
IR
HDMI
R L
R
R
L
R L
L
R L
R L
R L
VSX-AX4AVi
Personal computer
A-type USB
connector B-type USB
connector
VSX_AX4AVi.book.fm 51 ページ ２００５年６月２０日 月曜日 午後６時２７分