Panduit TDP46H - Manual (Page 42)

PANDUIT TDP4*H GMTDPH-MAN Page 3-16
Section 3: Configuration
This selection allows you to set the default character pitch to either
fixed character spacing or proportional character spacing
1. Use the LINE key to step the cursor to the desired setting.
2. Once the correct setting is selected, pressing the FEED key will
accept the setting and the display will return to the Advanced
Mode display
To exit the advanced mode, power the printer off and then back on.
CARD MODE
The Card Mode allows the operator to manage the Expanded Memory (PCMCIA Card or Internal Expanded
Flash ROM).
CHARACTER PITCH
PROP FIXED
ADVANCED MODE
Displays the firmware during the initialization. V 05.00.03.00
INITIALIZING
The Card Mode is entered from the Advanced Mode display by
pressing the LINE key once. ADVANCED MODE
The Card Mode display indicates that the printer is in the Card
Mode. To advance to the first selection, press the FEED key. CARD MODE
This selection determines which type of optional expanded memory
will be addressed as “CC1" in the command streams.The CARD
selection specifies the optional PCMCIA card as CC1 and the
optional Expanded Flash ROM as CC2. The Memory selection
specifies the optional Expanded Flash ROM as CC1 and the
optional PCMCIA card as CC2.
1. Step the cursor to the desired selection using the LINE key.
2. Once the cursor is positioned over the desired selection, press
the FEED key to accept the selection and advance the display.
MEM SELECT (CC1)
CARD MEMORY
This selection allows you to copy TrueType fonts from the PCMCIA
Memory card installed in the Memory Card slot on the rear of the
printer to the optional Flash ROM.
1. Use the LINE key to step the cursor to desired setting. If Yes is
selected, the printer will enter the Card Copy mode. If No is
selected, the display will advance to the Card to Memory SATO
Font Copy mode.
2. Confirm your selection by stepping the cursor to the Yes
selection. If you select No, the display will return to the previous
selection.
Press the FEED key to accept the selection. If Yes was selected the
copy process will start.
CARD->MEMORYCOPY
TRUETYPEFONT Y/N
COPY START
YES NO
TRUETYPEFONTCOPY
COPYING