NordicTrack NTL14950 - Manual (Page 7)

7
2. With the help of a second person, carefully tip the Frame
(55) and the Uprights (85) down to the position shown.
Make sure that the Base Extensions (90) remains in
place.
Carefully slide the Base Cover (92) onto the base of the
Uprights (85). Attach the Base Cover with four 3/4” Tek
Screws (44);
start all four Tek Screws before tighten-
ing them. Be careful not to overtighten the Tek
Screws.
92
90
44
55
85
90
2
3. Attach the Base Extensions (90) with four Extension
Screws (87); start all four Extension Screws before
tightening them.
Attach the two Thin Base Pads (83) to the base of the
Uprights (85) in the locations shown with two 1” Tek
Screws (82).
Note: Replacement Base Pads may be included. Use the
Base Pads to replace any that becomes worn.
With the help of a second person, carefully tip the
Uprights (85) back to the vertical position. 87
85
83
82
87
90
90
83
82
4. With the help of a second person, raise the Frame (55) to
the vertical position.
While the other person holds the Frame (55), press the
smaller end of the Shock (86) onto the bracket on the base
of the Uprights (85).
Make sure to orient the Shock as
shown. Press the other end of the Shock onto the bracket
on the Frame. Note: It may be necessary to tip the Frame
forward or back to attach the Shock.
Do not tip the Frame
forward past the vertical position.
Carefully lower the Frame (55) to the floor.
85
86
55
3
4