NordicTrack CX 938 NEL5095.2 - Manual (Page 5)

5
2. Have another person hold the Upright (2) in the posi-
tion shown.
Connect the Upper Wire Harness (30) to the Lower
Wire Harness (42). Insert the connectors on the Wire
Harnesses up into the Upright (2). Carefully pull the
upper end of the Upper Wire Harness to remove
the slack from the Wire Harnesses.
Insert the Upright (2) into the Frame (1). Be careful to
avoid pinching the Wire Harnesses (30, 42). Attach
the Upright with two M10 x 108mm Button Screws (70),
two M10 Split Washers (73), and two 7.6mm Spacers
(47). Make sure that the curved sides of the
Spacers are facing the Upright. Be careful to avoid
damaging the Wire Harnesses with the Button
Screws. Do not tighten the Button Screws yet.
2
30
70
Pull
42
1
73
73
47
2
47
3
31
29
28
Grease
2
96
29
3. Slide a Weld Spacer (28) onto the axle on the left side
of the Upright (2), with the open side of the Weld
Spacer facing the Upright. Apply a small amount of the
included grease to the axle.
Slide an Upper Body Arm (29) onto the axle on the left
side of the Upright (2). Using the included Push Nut
Tool (96), tap a Push Nut (31) onto the axle; make
sure that the Push Nut is turned as shown in the
inset drawing.
Attach the other Upper Body Arm (29) to the right
side of the Upright (2) in the same way.
26
2
26
4. Look inside one of the Handlebar Cover Sets (26) and
locate the square tabs connecting the two halves.
Gently lift the tabs and disconnect the halves.
Hold the two halves of the Handlebar Cover Set (26)
around the tube on the left side of the Upright (2). Align
the halves and press them together until they lock.
Attach the other Handlebar Cover Set (26) to the right
side of the Upright (2) in the same way.
See the inset drawing. Attach the Water Bottle Holder
(13) to the Upright (2) with two M4 x 16mm Screws
(94).
4
Axle
Axle 31
Do not pinch the
wire harnesses
during this step.
13
2
94