Nady Systems SPM-4250 - Manual (Page 8)

REAR CONTROLS AND CONNECTIONS
8
(25) PHANTOM POWER ON/OFF SWITCH
When this switch is depressed, +48V of phantom power will be supplied to the XLR mic inputs.
(26) SPEAKER OUTPUT JACKS
The left and right 1/4" speaker outputs can deliver up to 125W RMS per side to 4
Ω loads.
(27) POWER CONNECTOR
The IEC socket is used to connect the power cord to an AC power source.
(Caution: Do not remove the center grounding pin.)
(28) FUSE COMPARTMENT
Replace with only the same type fuse as listed in the SPECIFICATIONS. If it blows continuously, do not use the unit and
have it serviced by qualified personnel.
(29) AC VOLTAGE SELECTOR SWITCH
Before plugging in the power cord, check to see that the unit is set for the proper voltage for your area: ~115V (60Hz) or
~230V (50Hz).
(25)
(29)
(27)
(28)
(26)