NAD HTR-3 - Manual (Page 6)

Example: Record a Macro to the [0] key to turn ON the
NAD Receiver, turn ON the DVD Player, Select Input 1 and
commence disc playback of connected Input 1 device (as in
the DVD player):
• On the HTR 3, simultaneously press-and-hold [MACRO]
and [0] (numeric zero); the Learn LED turns steady green.
• Press [AMP], press [ON]; press [DVD], press [ON]; press
[AMP], press [1] (Input 1); press [DVD], press (Play).
• Press [MACRO] again to exit the macro-record mode.
To clear a macro, perform the above steps without entering
any functions.
EXECUTING MACROS
To execute a macro, press and release [MACRO]; its key
illumination lights for 5 seconds. While it remains lit, press an
HTR 3 key to which a macro has previously been stored.
The corresponding macro will run; as each step executes, its
“parent” DEVICE SELECTOR key flashes briefly; when execution
is finished, the [MACRO] key illumination goes out. Pressing
any other HTR 3 key while a macro is executing will abort the
macro. Remember that you must hold the HTR 3 so that its
infrared emitter can activate the target components.
NOTE
When a macro executes, a 1 second delay is automatically
inserted between its commands. If you need more than
a 1 second delay between particular commands—for
example, to permit a component to power up completely—
you can record “empty” steps into the macro by changing
DEVICE SELECTOR “pages” without entering actual
command functions.
BUTTON ILLUMINATION TIMEOUT
The HTR 3’s key-illumination can be set to remain lit for 0-9
seconds. The default value is 2 seconds. To set the illumination
timeout, simultaneously press-and-hold for 3 seconds both the
HTR 3’s [DISP] and the [0-9] key, with the digit corresponding to
the desired timeout duration; the Learn LED will flash twice to
confirm the new setting. When set to zero, the illumination will
not turn on at all.
NOTE
Key illumination is the biggest drain on the HTR 3’s
batteries. A short key-illumination timeout will extend
battery life appreciably; turning it off altogether (set it to 0
seconds) will lengthen it still further.
FACTORY RESET
The HTR 3 can be reset to its factory state, deleting all learned
commands, copied and punched-through keys, macros,
and other setup information; reverting all keys to their pre-
programmed library commands.
To perform a factory reset simultaneously press-and-hold for
10 seconds the HTR 3’s [ON] and [RTN] keys; the Learn LED will
start to flash green. Release [ON] and [RTN] before the second
flash is complete; the Learn LED will turn red, indicating the
remote has been reset.
NOTE
You must release [ON] and [RTN] before the second flash
goes out, otherwise the unit will not reset; should this
occur, repeat the full procedure.

EN
G
LIS
H
FR
A
N
Ç
A
IS
ES
PA
Ñ
O
L
IT
A
LIA
N
O
D
EU
TS
CH
N
ED
ER
LA
N
D
S
SV
EN
SK
A
РУ
СС
К
И
Й
HTR3_eng_OM_v02.indd 6 7/8/07 22:03:26